Triumph-Adler DC 2118 Specifications download pdf (Page 39)

Preparations

2-12

How to Load Originals

Before loading originals, be sure that there are no originals left on the original eject table. Originals

left on the original eject table may cause the new originals to jam.

Adjust the original width guides to fit the originals.

Note Before setting originals, make sure that there are no

originals remaining on the original eject table. Originals

left on the eject table may cause other originals to jam.

When setting multiple originals at one time, be sure to

use originals of the same size. It is, possible, however

to use different size originals of the same width (for

example, 11 x 17" (Ledger) and 11 x 8

1/2" or A4 and

A3 at the same time in the auto selection mode. Refer

to Chapter 4 Auto Selection Mode.)

Arrange the originals in order and set them face up

(front side up for 2-sided originals) on the original table.

Important! Be sure to set only a number of originals that does not

exceed the level indicator located inside the rear

original insert guide. If you set originals exceeding the

specified number, the originals may jam.

To keep ejected originals from falling off the machine,

open the ejection extension when using large originals

such as A3, B4, 11 × 17" (Ledger), and 8

1/2 × 14"

(Legal).

When copying from 2-sided originals, the originals are

temporarily ejected onto the ejection tray in order to

turn them over. Do not touch them at this point. Any

attempt to remove them may cause the originals to jam

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 107 108

No comments

Triumph-Adler DC 2118 Specifications Page 39