Triumph-Adler DC 2118 Specifications download pdf (Page 76)

7-1

7 Troubleshooting

If Trouble Occurs

If trouble occurs with this machine, carry out the items indicated below. If the trouble persists,

contact your service representative.

Symptom Items to check Corrective procedure Reference

page

Nothing is displayed on the

operation panel when the

main power switch is

turned on.

Is the power plug connected to an AC

outlet?

Connect the plug to an AC outlet. 3-1

No copies come out when

the Start key is pressed.

Is there any indication of the trouble on

the operation panel?

Check the appropriate measures

against that indication and carry out the

corresponding procedure.

7-4

The copies come out

blank.

Were the originals set correctly? When setting originals on the platen,

set them face-down along the original

size indicator plates.

3-1

When setting originals in the optional

document processor, set them face-up.

2-11

The copies come out too

light.

Is the auto density adjustment mode

set?

To adjust the overall density level,

perform the auto density adjustment

procedure.

Is the manual density mode set? Use the Lighter key or the Darker key

to adjust the density level properly.

3-2

To adjust the overall density, perform

the relevant density adjustment

procedure in each image quality mode.

Is the toner evenly distributed in the

toner container?

Shake the toner container horizontally

approximately 10 times.

6-5

Is the EcoPrint mode set? Do not set the EcoPrint mode. -

Is Adding Toner requested? Replace the toner container. 6-5

Is the copy paper wet? Replace the copy paper with new paper. 2-1

Is the electrical charge section dirty? Open the front cover and use the

charger cleaner rod to clean the

electrical charge section.

6-7